First, you can choose to push horizontally, that is, from the front. As shown in the figure below:

Second, you can also choose a chain, that is, align the small holes on both sides of the invoice with the teeth of the printer from the back.

Check the position of the paper feed lever, adjust the paper feed lever to the upper part as shown in the figure below, and confirm the position of the paper link icon.

2. Put the punched printing paper to be printed behind the printer (in the printer paper slot). The height of the printing paper should be lower than that of the printer. Before feeding paper, please press the figure below to adjust the spacer to 2 or 3.

3. In order to adjust the position of the chain paper clip, first loosen the paper clip locking lever upward as shown by the arrow in the figure. (When the paper clip locking lever is pressed, the chain paper clip will be locked. )

As shown in the figure below, there are two paper clips on the back of the printer. In order to support the printing paper, there is a paper feeding support block in the middle. The above three parts can move left and right.

5. Move the left chain paper clip to the device position indicated by the arrow on the back of the printer, lock the paper clip locking lever, move the right paper clip to the appropriate position (adjust the position according to the width of the printing finger), and move the support block to the middle of the two paper clips.

6. Open the paper clip according to the direction of the arrow in the figure below, connect the paper of the chain bill up and down through the paper loading shaft at the back of the printer, and then put it into the chain paper clip in a neat combination.

7. As shown below, aim at the paper holes on both sides, load the printing paper, close the paper clip, and check again whether the printing paper holes are aligned with the chain teeth (if not, will you go? May cause the printing paper to tear or get stuck) to lock the right paper clip locking lever.