1. The newly purchased Huhutong package comes with an instruction manual. Follow the instructions to assemble the Huhutong hardware. During assembly, all components must be firmly connected to ensure specifications and achieve the best acceptance effect. Then use the data cable to connect the satellite receiving port of the set-top box to the high-frequency head of the satellite receiving device, turn on the power of the set-top box, wait until the start-up of House-to-House Tong is completed, open the House-to-House Tong system menu, and switch to the "System Settings" tab. In the "System Settings" tab, press the "OK" button on the remote control, and in the pop-up "System Settings Requires Password" interface, enter the advanced authorization setting password "9999" and press the "OK" key to enter.

2. In the "Installation and Signal Detection" interface, switch to "Satellite" mode, adjust the elevation and direction angle of the household communication receiving device according to the actual local conditions, so that the "signal strength" reaches more than 70% , and ensure that the "signal quality" reaches above 30%, you can receive satellite signals normally. In the household-to-house debugging work, the most troublesome thing is the debugging of the receiver elevation and direction angle. It is best to make use of the relevant satellite parameter information in the user pass box to improve debugging efficiency.

3. After the signal debugging is completed, the prompt "The channel is not authorized and TV programs cannot be viewed normally" may appear. You only need to wait 3-5 minutes to resolve this. Or switch directly to channel 999 and follow the on-screen prompts to quickly complete the authorization operation.

4. When using User Pass, a prompt such as "Location module abnormality", "Location service has changed" or "Location information has changed, please contact the customer service center" appears, and the User Pass needs to be relocated. . That is, first switch to the "Restore Factory Settings" tab and press the "OK" key on the remote control to restore factory settings. Then switch to the "Network Connection Settings" tab, set the "Sending Protocol" to "TCP", set the "Network IP" to the IP set by the system, and set the "Network Port" to "04567". Finally, switch to the "Regional Code" tab and fill in the "Huhutong Regional Edit" based on the first six digits of the local ID card or the "Administrative District Code".

5. After debugging is completed, turn off the power of the set-top box and open the back cover of the set-top box. Insert the local mobile phone card into the SIM card slot and insert any local household encryption card at the same time. Turn on the phone and wait for the "Location module exception" to appear. ” prompt window appears, turn off the power of the set-top box. Then re-insert the original encryption card, turn on the power of the set-top box, and wait for more than 10 minutes. If there is no prompt message about "location", it means that the location has been repositioned successfully. Enter the "System Settings" interface again, switch to the "Base Station Information" tab, and wait until the relevant "Base Station Information" appears, allowing users to watch TV programs normally.