Legal analysis
If the flow rate is far below the minimum flow rate to ensure accuracy, there will be no output (such as vortex flowmeter) or the output signal will be cut off as a small signal (such as differential pressure flowmeter), which is unfavorable and unfair to suppliers. In order to prevent the loss of benefits, for a specific set of thermal energy metering equipment, the supply and demand sides often agree that a certain flow value is the "agreed lower limit flow" according to the flow measurement range and the achievable range, and agree that if the actual flow is less than the agreed value, it will be charged according to the lower limit flow. The metrological administrative department of the people's government at or above the county level may set up metrological verification institutions according to needs, or authorize metrological verification institutions of other units to perform compulsory verification and other verification and testing tasks. Personnel who perform the verification and testing tasks specified in the preceding paragraph must pass the examination. This function is usually realized in the flow display instrument. The metrological administrative department of the local people's government at or above the county level shall, according to the needs of the local area, establish public standard instruments of measurement, which shall be used after passing the examination presided over by the metrological administrative department of the people's government at a higher level. Enterprises and institutions may, as required, establish standards of measurement for their own use, and the highest standards of measurement shall be used after passing the examination presided over by the metrological administrative department of the relevant people's government. Metrological verification shall be carried out on site in accordance with the principle of economy and rationality. Metrological verification must be carried out in accordance with the national metrological verification system table. The national metrological verification system table shall be formulated by the metrological administrative department of the State Council.
legal ground
Article 201 of the Criminal Law of People's Republic of China (PRC) * * * A taxpayer who makes false tax returns or fails to make tax returns by deception or concealment, and evades paying a large amount of tax, accounting for more than 10% of the tax payable, shall be sentenced to fixed-term imprisonment of not more than three years or criminal detention and shall also be fined; If the amount is huge, accounting for more than 30% of the tax payable, he shall be sentenced to fixed-term imprisonment of not less than three years but not more than seven years and shall also be fined. If the withholding agent fails to pay or underpays the tax withheld or collected by the means listed in the preceding paragraph, and the amount is relatively large, it shall be punished in accordance with the provisions of the preceding paragraph. If the acts mentioned in the preceding two paragraphs are carried out many times without being dealt with, they shall be calculated according to the accumulated amount. Whoever commits the act mentioned in the first paragraph, after the tax authorities have issued a notice of recovery in accordance with the law, pays back the tax payable and the overdue fine, and is subject to administrative punishment, shall not be investigated for criminal responsibility; Except for those who have received criminal punishment for tax evasion within five years or have been given administrative punishment by tax authorities for more than two times.