How to output the log file from H3C switch to PC?Because usually through the serial port, after a while it is automatically ... -- Configure info-center loghost x.x.x.x x.x.x.x on the H3C switch as your log server address. First make sure that the switch and the log server network are available. Only then can you send the logs to the server.

How to view the logs of Huawei H3C Router -- 6. You can manage the logs in "System Monitor". Here you can send the logs to the server or not save them locally.

H3C Switch Common Configuration Commands -- [H3C-vlan2]port-isolate enable Turns on port isolation in the VLAN, which prevents Layer 2 forwarding. isolate uplink-port vlan 2 Set 4 as the isolated uplink port of VLAN 2 for forwarding Layer 2 data, only one uplink port can be configured, if it is trunk, it is recommended that ...

h3c f100-m-g firewall Inside the log can be output to a host? What are the requirements... -- Yes, it is possible. You need to have a syslog-enabled server or a computer with syslog software installed. After that set up the log host on the firewall to point to the server and you're good to go

How to send switch log messages to an audit server -- Log into the switch and set up syslog I've paired it before. Set up the level of logging information and the IP of your audit server. specifically here I can only give you a direction guide.

H3C Switch Configuration Commands -- H3C switches from the core backbone to edge access, more than 10 series of hundreds of products, all through the Chinese Ministry of Information Industry, Tolly Group, MetroEthernet Forum, and IPv6 Ready and other authoritative departments of the test and certification. and certification, the following I organized for you on the H3C switch configuration command, I hope to help you. I. User Configuration: ...

... And how to configure the switch's log server. Thank you for your help -- This is not available, it belongs to the H3C SOHO class of products, does not support the SNMP protocol, snmp protocol is a simple network management protocol, if it is the main product supports snmp. You can use H3C's IMC intelligent management platform to manage the device.

Reference:

H3C gold medal Reseller Engineer - for you to solve!

The H3C switch log problem -- indicates that a remote telnet user executed the command interface g7/0/41 on this switch. ip: is the ip address of the logger user: refers to the account number used by the logger. If you look up in the logs, you will see that the first login information for this user contains the word login ...

h3c how to turn on syslog -- H3C syslog configuration Configuration for S8016 ( VRP(R) Software, Version 3.10(NSSA), RELEASE 5331) S8016 new command line setup log server info-center enable //open info-center inf-center loghost host-ip-addr channel 2 facility local-number...

How to view the switch log file -- 1, first double-click to open the robotframework interface, select to open the tools option in the run tests settings. 2, and then appear in the interface, you can see the diary log directory. 3, and then open the computer Then open the browser on the computer, click the address bar, enter the diary directory you want to see, enter OK. 4, and finally in the pop-up ...